Electrical installation
Common control terminals
Important notes
6
l
205
EDS84ASC552 EN 8.1
Shield and connect cables
The uncovered cable shield at the left shield lug of the stripped control cables must be
connected 0 using a (metal) cable tie for high conductivity.
As shown in the illustration, the cable ends (if required, provided with wire end ferrule)
must be inserted into the corresponding spring terminals with a suitable screwdriver (for
max. width, see illustration).
8400SLC018
Fig. 6−24 Shielding and connecting control cables
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
