Maintenance
Leuze electronic BPS 8 115
TNT 35/7-24V
11 Maintenance
Usually, the BPS 8 does not require any maintenance by the operator.
11.1 Cleaning
In the event of dust build-up, clean the optical window with a soft cloth; use a cleaning agent
(commercially available glass cleaner) if necessary.
Also check the bar code tape for possible soiling.
11.2 Repairs, servicing
Repairs to the device must only be carried out by the manufacturer.
Contact your Leuze distributor or service organization should repairs be required.
The addresses can be found at www.leuze.com.
When sending devices to Leuze electronic for repair, please provide an accurate
description of the error.
11.3 Disassembling, packing, disposing
Repacking
For later reuse, the device is to be packed so that it is protected.
CAUTION
No solvents, no acetone!
Do not use solvents or cleaning agents containing acetone for cleaning!
Use of improper cleaning agents can damage the optical window.
NOTE
Electrical scrap is a special waste product!
Observe the locally applicable regulations regarding disposal of the product.
To Next Page
Loading...
