Leuze BPS 8 - Overview of the Parameter Structure

Configuration / device parameters
Leuze electronic BPS 8 70
TNT 35/7-24V
8.4 Overview of the parameter structure
Using the BPS Configuration Tool program, parameters can be changed via the service
interface. These parameters are separated into individual tabs in the Graphical configura-
tion menu.
The following tabs are available:
Tab name Folder contents
Control
Page 72
• Measurement start mode
• Measurement stop mode
• Maximum polling interval
Position detection
Page 73
• Resolution for the position value
• Integration time
• Preset value added to tape value
• Counting direction for position calculation
• Scaling factor
• Offset value
• Maximum permitted measurement length
• Minimum permitted measurement length
• Position tolerance time
• Error output delay
Communication
Page 78
• Baud rate
• Data mode
•Protocol
• Address
Switching input
Page 80
• Inversion
• Mode
• Debounce time
• Start-up delay
• Pulse duration
• Switch-off delay
• Function
Switching output
Page 82
• Activation
• Deactivation
• Pulse duration