Safety
Leuze electronic BPS 8 6
TNT 35/7-24V
2Safety
The bar code positioning systems of the BPS 8 series and the MA 8… modular connection
unit have been developed, produced and tested subject to the applicable safety standards.
They correspond to the state of the art.
2.1 Intended use
The bar code positioning system of the BPS 8 series is an optical measuring system which
uses visible red laser light to determine the position of the BPS relative to a permanently
mounted bar code tape.
The optional connector and interface unit MA 8… is intended for the easy connection of bar
code positioning systems of type BPS 8.
Areas of application
The BPS 8 bar code positioning systems are designed for the following areas of application:
• Crane bridges and trolleys
• High-bay storage devices
• Side-tracking skates
• Telpher lines
•Elevators
NOTE
Declaration of Conformity
A copy of all declarations of conformity available for the product can be found in the
appendix of this handbook (see chapter 13.1 "EC Declaration of Conformity" on
Page 119).
CAUTION
Observe intended use!
The protection of personnel and the device cannot be guaranteed if the device is operated
in a manner not complying with its intended use.
Only operate the device in accordance with its intended use.
Leuze electronic GmbH + Co. KG is not liable for damages caused by improper use.
Read these operating instructions before commissioning the device. Knowledge of
this document is required in order to use the equipment for its intended purpose.
NOTE
Comply with conditions and regulations!
Observe the locally applicable legal regulations and the rules of the employer's liability
insurance association.
To Next Page
Loading...
