Mounting and installation
Leuze electronic BPS 8 39
TNT 35/7-24V
6.1.4 BCB repair with repair kit
If a bar code tape was damaged, e.g., by falling parts, you can download a repair kit for the
BCB from the Internet.
www.leuze.com > Products > Measuring Sensors > Sensors for Positioning > Bar
code positioning systems > BPS 8 > (Name of the BPS 8) > Tab Downloads > Repair
kit.
In the repair kit files, you will find all position values with 30 mm grid.
The repair kit PDF files each contain a value range of 500m. The following value ranges are
available:
• 0 … 500m
• 500 … 1000m
• 1000 … 1500m
etc. up to
• 9500 … 9999m
You can find the repair kit PDF files with position bar codes in a 40 mm grid in the download
area of our BPS 300i bar code positioning systems.
NOTE
Do not use the BCB repair kit on a permanent basis!
Use the bar code tape created with the repair kit only temporarily as an emergency
solution.
The optical and mechanical properties of the self-printed bar code tape do not corre-
spond to those of the original bar code tape.
Self-printed bar code tape should not remain in the system on a permanent basis.
Original repair tapes in lengths of 1 m can be ordered from Leuze electronic on
request.
To Next Page
Loading...
