Leuze BPS 8 - Page 3

Leuze electronic BPS 8 2
Table of contents
7 Electrical connection ....................................................................................................... 48
7.1 Safety notices for the electrical connection........................................................................ 48
7.2 Electrical connection BPS 8............................................................................................... 49
7.2.1 BPS 8 - PWR IN - Voltage supply, RS 232, Switching input/output ............................................49
7.3 Electrical connection via connection unit MA 8.1 ............................................................... 51
7.3.1 Electrical connection MA 8.1 ....................................................................................................... 51
7.3.2 PWR IN HOST/RS 232 connector – voltage supply and RS 232 ................................................ 52
7.3.3 SW IN/OUT socket – switching input and switching output .........................................................53
7.3.4 BCL socket – connecting the BPS 8 to the MA 8.1 ..................................................................... 55
7.4 Electrical connection via connection unit MA 8-01 / MA 8-02 ............................................ 56
7.4.1 PWR IN HOST/RS485 connector – voltage supply/RS 485........................................................56
7.4.2 SW IN/OUT socket – switching input and switching output .........................................................57
7.4.3 BCL/BPS socket – connecting the BPS 8 to the MA 8-01/MA 8-02 ............................................ 59
7.4.4 Termination of the RS 485 interface............................................................................................ 60
8 Configuration / device parameters................................................................................. 61
8.1 RS 232/RS 485 interface ................................................................................................... 61
8.1.1 General information ..................................................................................................................... 61
8.2 BPS Configuration Tool software....................................................................................... 62
8.2.1 Installation of the BPS Configuration Tool software .................................................................... 62
8.2.2 Brief manual for the BPS Configuration Tool............................................................................... 63
8.2.3 Setting the parameters ................................................................................................................67
8.3 Service operating mode ..................................................................................................... 68
8.3.1 Activate service interface............................................................................................................. 68
8.3.2 Connecting the service interface ................................................................................................. 68
8.3.3 Overview of commands and parameters.....................................................................................69
8.4 Overview of the parameter structure.................................................................................. 70
8.5 Detailed description of the tabs.......................................................................................... 71
8.5.1 Control ......................................................................................................................................... 72
8.5.2 Position detection ........................................................................................................................ 73
8.5.3 Communication............................................................................................................................ 78
8.5.4 Switching input.............................................................................................................................80
8.5.5 Switching output .......................................................................................................................... 82