Page 12
CONSOLE SETUP
The console has different operating options that can be setup from the console to the user's preference. If more than
one console is being used, it is required that you give each console a different address. You can change the address
of a console through the console setup mode.
To enter the console setup mode, simultaneously press and hold the 4 and up arrow () for approximately 1 second.
The console will beep 5 times and enter the setup mode. The top line of the display will indicate what you are doing,
followed by the current setting. The bottom line will show a menu of your options. To the lower right corner of the
display is the direction arrow(s). Where possible, the up (
↑), down (↓), and two-headed () arrow characters are
shown on the console display to indicate which arrow keys may be pressed at that time. Press the down arrow ()
key to advance to the next item. Press the up arrow () key to go back to the previous item.
CONSOLE ADDRESS
If you are installing more than one console, each console must be set to a different address. The default address
setting is (1) - this is adequate if only one console is being used. The choices at the bottom are 1-16. When making
your choice, choose an address between 1-4, and press the # (pound) key.
SOUNDER
If you wish not to hear the beeper in the console for any reason, the sounder option can be turned off. Select (0) for
OFF or (1) for ON, then press the # key.
KEY CLICK
The sounder makes a click every time a key is pressed. This option may also be turned off. Select (0) for OFF or (1)
for ON, then press the # key.
KEY BACKLIGHT
The keys on the console keypad are lit. The keys can be never lit, always lit, or only lit when the LCD display is lit.
Select (0) OFF, (1) for ON, or (2) TIMED, then press the # key.
VIEWING ADJUSTMENT
This option is an adjustment for the viewing angle of the LCD display. This has been set to its best value at the
factory, however, you may wish to tweak it. The display has 20 levels of adjustment. Select (1) for a lower viewing
angle, or (2) for a higher viewing angle.
LANGUAGE
This option is to display the 'console setup' text on the LCD display in English, French, Italian, or Spanish. Select one
of the languages, then press the # key.
EXIT SETUP MODE
To exit Setup Mode, press and hold the 4 and up arrow ( ) keys simultaneously for about 1 second. The console will
return to normal operation. You may need to press (*) to restore the display.
To Next Page
Loading...
