Leviton omnilte - Pc Access Code; Call Back Phone Number; Outside Siren Delay; Dial out Delay

Page 47
PC ACCESS CODE
This code allows dealers to put an access code in the system that is separate from the customer's Master code and
the Installer code. Dealers can use the PC Access code to access the system by PC. The PC Access code cannot
arm and disarm the system. The PC Access code is NOT programmed from the factory. To use it, set it to any code
other than 0000. To disable the PC Access code, enter 0000 for the code.
NOTE: This item must be enabled (by entering a code) if PC Access is will be used.
PC ACCESS CODE:
0000-9999 0000=DISABLE
CALL BACK PHONE NUMBER
In response to a request for remote PC ACCESS using the PC ACCESS code, the system will hang up and dial this
number back immediately. To program the CALLBACK PHONE NUMBER, enter the number then press ' # '. To
remove the CALLBACK PHONE NUMBER, press the OFF key to enter a single "-", then press ' # '.
CALL BACK PHONE NUMBER:
- 
OUTSIDE SIREN DELAY
If an output is configured as an "Exterior Sounder", when the alarm is "tripped", the interior sounder is turned on first.
After the OUTSIDE SIREN DELAY, the outside sounder is turned on.
This feature helps reduce annoying false alarms by signaling inside the premises first. The outside siren delay is set
to 15 seconds at the factory. You may change it to any value from 0 to 60 seconds. If you want the outside sounder
to turn on immediately when the alarm is activated, set the delay to 0. We recommend a minimum time of 15 seconds.
DIAL OUT DELAY: 15
0-60 SECONDS 
DIAL OUT DELAY
The DIAL OUT DELAY is the number of seconds that the Omni LTe waits before making an emergency dial out,
AFTER the alarm is "tripped" (activated by burglar or fire) to preclude an accidental activation of the alarm from calling
in a false alarm. This delay is set at the factory to 30 seconds.
Note: The DIAL OUT DELAY may be disabled for each individual zone (See – Zone Options).
DIAL OUT DELAY: 30
15-45 SECONDS 
ALARM RESET TIME
The Alarm Reset Time is the time it takes before the alarm system resets itself after the alarm is tripped.
ALARM RESET TIME: 6
6-30 MINUTES 
To change the alarm reset time, enter a new time between 6-30 minutes, then press the ' # ' key.
The default setting is 6 minutes.
WEB VERSION