Page 50
PICKUP AFTER HANGUP
This item is used to disable Omni LTe from picking up the phone line after the called party hangs up the line.
PICKUP AFTER HANGUP: 1
0=NO 1=YES
Currently, after the called party or the called party's answering machine hangs up the phone line, Omni LTe picks up
the line and make its "Beep". If you wish to turn the Pickup After Hangup OFF, press 0 then ' # '. To turn it back On,
press 1 then ' # '.
The default setting for Pickup After Hangup is Yes.
CLOCK ADJUSTMENT
If the clock on an Omni LTe is running faster or slower than the actual time, you can have the Omni LTe automatically
compensate up to 29 seconds per day. The Omni LTe will add or subtract the selected amount of time daily.
CLOCK ADJUSTMENT: 30
1-59=-29 TO +29 SEC/DAY
Enter 1-29 to subtract 1-29 seconds. Enter 31-59 to add 1-29 seconds. Enter 30 for no adjustment to the clock.
The default setting is 30.
MODEL AND SOFTWARE VERSION
Next, the model number and software version for the system is displayed:
LEVITON OMNI LTE
S/W VERSION 3.11
RESET SYSTEM EEPROM
Select the 1 (YES) key to reset the EEPROM. All programs, names, and setup items will be reset. All system RAM
will also be initialized and the system will restart. This option, if effect, allows the system to be restored to factory
fresh configuration.
RESET SYSTEM EEPROM? 0
0=NO 1=YES
RESET SYSTEM RAM
Select the 1 (YES) key to cause all of the system RAM to be reinitialized. The time, date, and event log will be
cleared. Other volatile memory locations will also be reinitialized. The system RAM should only be reset if the system
is acting strangely and memory corruption is suspected. Resetting the system RAM will not reset any setup items
stored in EEPROM.
RESET SYSTEM RAM? 0
0=NO 1=YES
ETHERNET MAC ADDRESS
The Ethernet MAC Address, short for Media Access Control address, is the hardware address that uniquely identifies
Omni LTe when connected to a network.
ETHERNET MAC ADDRESS
FF-FF-FF-FF-FF-FF
↑
To Next Page
Loading...
