Page 46
To enable or change a thermostat type, press the ' # ' key. Use the arrow keys to scroll through the list of thermostat
types, then press ' # ' to select a new type
. The display shows:
SELECT TYPE: 1
AUTO HEAT/COOL ↓
TYPE NUMBER DESCRIPTION
AUTO HEAT/COOL 1 Automatic changeover heat and cool thermostat
HEAT/COOL 2 Manual changeover heat and cool thermostat
HEAT ONLY 3 Heating only thermostat
COOL ONLY 4 Cooling only thermostat
SETPOINT ONLY 5 Setpoint only thermostat
Z-WAVE THERMOSTAT NODE ID
If Z-Wave Thermostats are part of the system, the Node ID for the thermostat must be associated (mapped) with the
specified thermostat address in the Omni LTe controller.
TSTAT 1 NODE ID: 0
0-232
THROUGH
TSTAT 4 NODE ID: 0
0-232 ↑
Enter the Node ID (0-232) for each Z-Wave thermostat followed by the ' # ' key.
Enter 0 if there is no node associated to the specified thermostat.
SETUP MISCELLANEOUS
To configure the miscellaneous Installer Setup items, from the Installer Setup menu, press the 6 (MISC) key.
INSTALLER CODE
The Installer code allows the installer access to the Installer Setup menu. The Installer code should be changed and
not given to the customer. The Installer code cannot be used for remote phone access.
INSTALLER CODE:
0000-9999 0000=DISABLE
↓
The default setting for the Installer code is 1 1 1 1.
NOTE:
Remember this Installer code and do not disable. There is no way to reset or retrieve the code! If the code is
forgotten or disabled, the Omni LTe controller must be sent back to the factory. Call for an RA number.
ENABLE PC ACCESS
This enables or disables the PC ACCESS feature. Factory default is enabled.
ENABLE PC ACCESS: 1
0=NO 1=YES
To Next Page
Loading...
