Page 43
SETUP DIGITAL COMMUNICATOR
To setup the Digital Communicator, from the Installer Setup menu, select the 3 (DCM) key.
FIRST PHONE NUMBER, FIRST ACCOUNT NUMBER
The first item in the DIGITAL COMMUNICATOR category is the FIRST PHONE NUMBER. Enter the FIRST PHONE
NUMBER on the keypad. This enables the Digital Communicator.
You can cause a 2-second pause during dialing by pressing the DAY key.
To prevent a call waiting line from interfering with the dial out, you may use the call waiting cancel sequence at the
beginning of the number. The call waiting sequence is typically ' * 7 0 T ' (T = pause); however this may vary
depending on your region.
If you are using the call waiting sequence, only use it on the “FIRST PHONE NUMBER”; do not use it on the
“SECOND PHONE NUMBER”.
FIRST PHONE NUMBER:
-
↓
To disable the digital communicator, enter a single "-" for the FIRST and SECOND PHONE NUMBER by pressing the
OFF key, then ' # '. Phone number may be up to 24 digits long.
Press the down arrow () to advance to the FIRST ACCT NUMBER:
FIRST ACCT NUMBER: 0000
0-FFFF
Enter the 4 digit account number (3 digits if using 3/1 format) and press ' # '. To enter the digits B-F, first press the
OFF key, then press the 1-5 key respectively (i.e. 1B11 = 1 OFF 1 1 1 #).
NOTE: You must enter 4 digits for the account number if you are using 4/2 format (i.e. 0123), and 3 digits if using 3/1
(i.e. 123).
SECOND PHONE NUMBER, SECOND ACCOUNT NUMBER
Enter these if used.
Note: do not use the call waiting sequence on the “SECOND PHONE NUMBER”.
SECOND PHONE NUMBER:
-
SECOND ACCT NUMBER: 0000
0-9999
COMMUNICATOR TYPE
This item is used to select the transmitting parameters of the digital communicator. The Omni LTe can transmit in
FAST 2300 Hz (20 PPS) mode, in SLOW 1400 Hz (10 PPS) 3/1 format, and in Contact ID.
COMMUNICATOR TYPE: 2
0=2300 1=1400 2=ID
The default setting is 2 = ID (Contact ID). If you need to transmit to a 4/2 or 3/1 receiver, select the proper
handshaking frequency (2300 Hz or 1400 Hz) and press ' # '.
To Next Page
Loading...
