Page 52
LEVITON Access Control
LEVITON Access Control allows you to access doors by opening an electric or magnetic lock, arm and disarm the
security system, and achieve many home automation functions such as controlling lighting, energy management,
surveillance, and audio. The Access Control Reader is a 125 KHz high security, digitally encrypted, 26-bit proximity
card reader. It has durable and scratch resistant polycarbonate housing and full epoxy potting which ensures
successful operation even in harsh environments.
Omni LTe can have up to 4 LEVITON Access Control Readers connected.
Enrolling Access Control Readers
When enrolling an Access Control Reader, the following configuration items are part of the enrollment process:
• Link assignment (link to another Access Control Reader)
• Unlock Time
• Exit Time
• Lock Type
• Beeper (enable or disable)
• Arming and disarming
Note: These items should be configured prior to enrolling the Access Control Reader.
READER 1 ADDRESS:
0.0.0.0 #=CFG
Press the ' # ' (#=CFG) key to put the system into configuration mode. The display will show:
CONFIGURE READER 1
SWIPE CARD 3 TIMES
Go to the Access Control Reader to be enrolled and swipe any LEVITON Access Control Card or Key Tag 3 times in
front of the reader:
READER 1 ADDRESS:
8.5.0.137 #=DEL
Note: you have 3 minutes to complete the operation once the system is put into configuration mode. If an LEVITON
Access Control Card or Key Tag has not been swiped 3 times within the first 3 minutes, the controller will
automatically exit configuration mode.
Deleting Access Control Readers
To delete an Access Control Reader that is enrolled in the system, scroll down to the particular “Reader Address”
menu item, and then press the ' # ' (#=DEL) key.
READER 1 ADDRESS:
8.5.0.137 #=DEL
You will first be prompted to confirm deletion:
DELETE READER 1?
0=NO 1=YES
Deleting an Access Control Reader will take it out of the system and it will not be valid any longer.
To Next Page
Loading...
