20
ENFRDECZSKFREEFREE PL
9.3. CHARGE LEVEL DISPLAY
The charge level of the battery is permanently displayed during your ride. The number of LEDs glowing BLUE
indicates the remaining battery charge (Fig. 9.5). When the battery charge reaches 10%, the last LED will glow
RED (Fig. 9.5).
<
90-100
80-89
70-79
60-69
50-59
40-49
30-39
20-29
10-19
0-9
9.5
At 15% - 20% battery charge remaining, the system will start to reduce the amount of motor support to ensure
continuous assistance at lower charge levels. At 3% - 5%, the system switches off motor support, leaving the bike
powered on. This not only supports battery health and lifetime, it also allows you to keep wired lights powered for
about 2 hours.
The actual state of charge to trigger motor shut-off can deviate from the norm, depending on some variables like
cell temperature or discharge scenario (e.g. single vs. parallel discharge). Based on these variables, the Battery
Management System decides when best to shut off in order to protect itself and maintain the best battery health
possible.
If your bicycle is at a standstill for at least 15 minutes, the system will turn itself off to save power. In order to
continue riding with support, you have to turn the system on again.
9.4. CLEANING
Always turn the battery off and remove the charger from the charge port and wall socket before cleaning the
bicycle.
Make sure the charge port is properly closed before washing.
If your bicycle is fitted with a RE, remove the connector from the charge port and close the charge port before
cleaning.
Make sure the charge port is free from water and/or dirt, the port should be clean before use. Make sure the
system is switched off before cleaning. Blow out the contamination with low air pressure or use a soft brush to
remove dry contamination.
Make sure the charge port is completely dry before connecting the charger or the RE. Always close the charge
port when the internal battery is not being charged or the RE is not in use.
CAUTION: Never use a high-pressure cleaner or hose when cleaning your LEVO SL. Best practice
is to use a bucket of water with a wet cloth or a sponge to remove dirt, then dry off all surfaces
with a clean towel.
For instructions on how to clean drivetrain components, please refer to the drivetrain
manufacturer’s instructions. Make sure connectors are dry and clean before reconnecting and
riding. Ask your Authorized Specialized Retailer for additional information about cleaning your
bicycle.
CAUTION: Do not use alcohol, solvents or abrasive cleaners to clean the charger. Instead, use a
dry or slightly damp cloth.
To Next Page
Loading...
