Check [src] orientation or guides
Try one or more of the following:
• Move the paper guides in the tray to the correct positions for the paper size loaded.
• Make sure the paper size setting matches the paper loaded in the tray:
1 From the printer control panel Paper menu, check the Paper Size setting.
2 Before sending the print job, specify the correct size setting:
– For Windows users, specify the paper size from Print Properties.
– For Macintosh users, specify the paper size from the Page Setup dialog.
Close cover [x]
Close the specified cover to clear the message.
Close door [x]
Close the specified door.
Disk corrupted
The printer attempted a hard disk recovery on a corrupted hard disk, and the hard disk cannot be repaired. The hard
disk must be reformatted.
Touch Format disk to reformat the printer hard disk and clear the message.
Note: Formatting deletes all the files stored on the printer hard disk.
Empty the hole punch box
1 Empty the hole punch box.
For instructions on emptying the hole punch box, from the printer control panel touch More Information.
2 Reinsert the hole punch box into the finisher, and then touch Continue to clear the message.
Error reading USB drive. Remove USB.
An unsupported USB device has been inserted. Remove the USB device, and then install a supported one.
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
Insert staple cartridge
Try one or more of the following:
• Insert a staple cartridge.
• Touch Continue to clear the message and print without using the staple finisher.
Troubleshooting 215
To Next Page
Loading...
Need help?
General
