34 Incorrect paper size, check [paper source]
Try one or more of the following:
• Load the appropriate paper or specialty media in the proper tray.
• Confirm that the wheel on Tray 1 is set to the paper size loaded in the tray. Make sure the paper size matches the
document you are trying to print.
• Touch Continue to clear the message and print using a different tray.
• Check the tray length and width guides and make sure the paper is loaded properly in the tray.
• Make sure the correct paper size and type are specified on the Print Properties or Print dialog settings.
• Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make sure the paper
is large enough for the data being printed.
• Cancel the print job.
34 Incorrect paper type, check [paper source]
Try one or more of the following:
• Load the appropriate paper or specialty media in the proper tray.
• Confirm that the wheel on Tray 1 is set to the paper type loaded in the tray. Make sure the paper type matches the
document you are trying to print.
• Touch Continue to clear the message and print using a different tray.
• Check the tray length and width guides and make sure the paper is loaded properly in the tray.
• Make sure the correct paper size and type are specified on the Print Properties or Print dialog settings.
• Check that the paper type is correctly set. For example, if the MP Feeder Type is set to Universal, then make sure
the paper is large enough for the data being printed.
• Cancel the print job.
35 Insufficient memory to support Resource Save feature
Try one or more of the following:
• Touch Continue to disable Resource Save and continue printing.
• To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and then exit the
menus to activate the link buffer changes. When Ready appears, enable Resource Save.
• Install additional memory.
37 Insufficient memory, some held jobs will not be restored
The printer was unable to restore some or all of the confidential or held jobs on the printer hard disk.
Touch Continue to clear the message.
37 Insufficient memory, some Held Jobs were deleted
The printer deleted some held jobs in order to process current jobs.
Touch Continue to clear the message.
Troubleshooting 220
To Next Page
Loading...
Need help?
General
