Load Manual Feeder with [paper type] [paper size]
Try one or more of the following:
• Load the specified paper in the manual feeder.
• Touch Prompt each page, paper loaded or Do not prompt, paper loaded to clear the message and continue printing.
• Touch Automatically select paper to use the paper loaded in the tray.
• Cancel the print job.
Manual feeder expects [paper size]. Check [paper source] guides
Try one or more of the following:
• Load the specified paper size in the manual feeder.
• Physically adjust [paper source] guides to a recognized paper size.
• Touch Continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot
find a tray with the correct paper type and size, then it prints from the default source.
Load staples
Try one or more of the following:
• Replace the specified staple cartridge in the finisher.
• Touch Continue to clear the message and continue printing.
Note: The print job will be stapled if the staple cartridge is replaced or inserted.
• Touch Cancel job to cancel the print job.
Remove paper from standard output bin
Remove the stack of paper from the standard exit bin.
Remove paper from bin [x]
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from all bins
Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from [linked set bin name]
Remove paper from the specified bin. The printer automatically detects paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Troubleshooting 218
To Next Page
Loading...
Need help?
General
