Lexmark E240n

4511-xxx
2-62 Service Manual
54 Std Network
Software Error
This error displays when a network port is
detected, but the printer cannot establish
communications with it.
Press Go to clear the message. The printer
disables all communications to the network
interface.
55 Unsupported
Flash
An unsupported flash option is installed in the
DIMM slot. Turn off the printer, and remove the
unsupported flash option in the specified slot.
56 Std Parallel
Port Disabled
This error is displayed when data is sent to the
printer across the parallel port, but the parallel
port has been disabled. Once this message is
displayed, reporting of further errors is
suppressed until the menus are entered, or
the printer is reset. The following actions may
be taken:
• Press Go to clear the message. The printer
discards any data received on the parallel
port.
• Press Menu until Job Menu appears, and
select Reset Printer.
56 Standard USB
Port Disabled
Displayed when status is requested over the
USB port, but the port has been disabled.
Once the error has been displayed for the first
time, reporting of further errors is suppressed
until the menus are entered or the printer is
reset.
The following actions may be taken:
• Press Go to clear the message. The printer
discards any data received on the USB
port.
• Press Menu until Job Menu appears, and
select Reset Printer.
58 Too Many
Trays Attached
This error displays when too many input trays
are attached to the printer.
User attendance messages (continued)
Message Explanation