2-90 Service Manual
4500
Poor fusing of image
Light print
FRU Action
Fuser lamp The fuser may not be operating at
the proper temperature to fuse the
toner to the paper. See “Hot fuser
service check ” on page 2-76.
Paper (not a FRU) Make sure recommended paper is
being used.
FRU Action
Toner cartridge (not a FRU) Make sure the toner cartridge is
installed correctly and is not low on
toner.
If the problem continues, install a
new toner cartridge.
Tr an sfer ro ll
HVPS contact (transfer roll)
HVPS board
Check the transfer roll for signs of
toner buildup and contamination.
Inspect the HVPS contact (transfer
roll) for contamination.
Inspect the HVPS board for
contamination where it meets the
HVPS contacts.
If all components appear free of
contamination, replace the following
FRUs one at a time in the order
shown:
• Transfer roll
• HVPS contact (transfer roll)
• HVPS board
To Next Page
Loading...
