Repair information 4-5
4500
Right side cover
1. Open the front cover. See “Front cover” on page 4-4 for more
information.
2. Press the two right side cover finger tabs while releasing the
center tab.
3. Remove the right side cover.
Left side cover
1. Open the front cover. See “Front cover” on page 4-4 for more
information.
2. Remove the top cover. See “Top cover” on page 4-4 for more
information.
3. Remove the left side cover screw.
4. Release the left side cover tabs (2).
5. Remove the left side cover.
Auto sheet feed (ASF) assembly removal
1. Open the front cover. See “Front cover” on page 4-4 for more
information.
2. Remove the top cover. See “Top cover” on page 4-4 for more
information.
3. Remove the left side cover. See “Left side cover” on page 4-5
for more information.
4. Remove the right side cover. See “Right side cover” on
page 4-5 for more information.
5. Remove the two lower ASF screws.
6. Tilt or swing the lower rear auto sheet feed cover away from the
printer and remove.
7. Remove the two upper ASF screws.
8. Remove the ground strap screw attached at the gear drive.
9. Tilt or swing the top of the ASF away from the printer to
disengage the elongated hinge pivots.
10. Remove the auto sheet feed.
To Next Page
Loading...
Need help?
General
