4-12 Service Manual
4500
Paper feed clutch solenoid removal
1. Remove the front cover. See “Front cover” on page 4-4 for
more information.
2. Remove top cover. See “Top cover” on page 4-4 for more
information.
3. Remove rear auto sheet feed cover. See “Auto sheet feed
(ASF) assembly removal” on page 4-5 for more information.
4. Remove right side cover. See “Right side cover” on page 4-5
for more information.
5. Remove controller card cage. See “Controller card cage
removal” on page 4-7 for more information.
6. Disconnect the drive motor cable.
7. Remove optional Tray 2 connector from bracket.
8. Remove the four main drive gear assembly screws.
9. Remove the main drive gear assembly with drive motor from
printer.
10. Depress paper feed solenoid locking tab and slide paper feed
solenoid off D–roll assembly shaft.
11. Remove the toner cartridge.
12. Tilt the printer carefully to the rear so it is resting on the ASF.
13. Remove the four bottom cover screws.
14. Disconnect paper feed clutch solenoid cable from engine card
(E320/E322 only). Extract the cable for all models.
15. Remove the paper feed clutch solenoid.
To Next Page
Loading...
Need help?
General
