3-14 Service Manual
4500–E320/E322
Configuration mode
The configuration mode allows the setting of certain printer functions
through the operator panel that cannot be modified using the data
stream.
The following settings may be modified or selected in configuration
mode:
• Parallel port settings
– Enable port
– NPA mode
–Protocol
– Mode 1
– Mode 2
– Strobe adjust
• USB settings
– Enable port
– NPA mode
• PPDS activated
• Auto line feed carriage return (LFCR)/carriage return line feed
(CRLF)
Auto line feed after a carrier return, auto carrier return after a
line feed, and PPDS activated settings may be modified
using printer job language (PJL). However, modifications of
these settings are typically required by non PC users, so the
Lexmark E32x utilities may not be used to modify these
settings.
To Next Page
Loading...
