Diagnostic aids 3-31
4500–E320/E322
Auto CRLF/LFCR
Note: Auto CR after LF = on and auto LF after CR = on can only be
set through PJL. The printers configuration mode only allows
the user to set one or the other to on, or both to off. If
configuration mode is entered and both settings are set to on,
the initial value displayed shows both values off.
Off/on/auto Setting value
❍ Auto CR after LF = off and
Auto LF after CR = off.
● Auto CR after LF is on and
Auto LF after CR is off.
✳ Auto CR after LF is off and
Auto LF after CR is on.
To Next Page
Loading...
Need help?
General
