Chapter 2 - Operation
37
2.5.3 Operation via Keypad
1. Check the LCD display when Power ON. Otherwise, change the setting indicated above.
2. Set the Ref. Freq to 60 Hz using PROG/ENT/SHIFT, ? keys. Setting freq is displayed during stop.
3. When pressing FWD/REV key, motor starts running and output freq and output current are displayed.
4. Press STOP/RESET key. Then motor decelerates to stop. Setting freq 60Hz is displayed.
DRVâ–¶K/K 0.0 A
00 STP 0.00Hz
DRVâ–¶K/K 0.0 A
00 STP 60.00Hz
DRVâ–¶K/K 5.0 A
00 FWD 60.00Hz
DRVâ–¶K/K 0.0 A
00 STP 60.00Hz
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu