How to reset wireless call station and receiver of the lift
To reset a wireless call station so it is no longer paired with a particular lift, do as follows:
- Set dip switch S4 #1 to ON and press on the contact or connect (↑) or (↓) using a metal
object. The control LED on the call station will flash rapidly.
- The pairing with the receiver has now been erased.
- Return dip switch S4 #1 to off.
How to reset the receiver of the lift
- Switch the power to the lift on.
- Short-circuit JP1-1on the connection box board.
- When the control LED begins to flash rapidly, the receiver has been reset.
- Should the control LED not flash rapidly, this means that no receiver has been paired.
To Next Page
