1.2 Unpacking and moving the lift
After opening the wood or carton pallet, you need to remove all packaging around the lift.
The lift is equipped with batteries. Even if the power supply is not connected to the lift, the lift
can move. To start moving the lift you need to make some changes on the safety circuit of the
product as it is by default delivered with all safety functions active.
Remove the cover for the control box to access the primary control board (always right-hand
side of the lift).
In order to move the product, place a jumper
on:
- Upper Gate SW
- Under Pan SW
If you now release the emergency button, you
should have all green LED’s on (see photo).
To Next Page
