Service Training
Section 4.3
Page 4
- Remove any lateral play in the overhead guard with shims (9).
- Install the bearing brackets (7) and torque the screws (10) to 80 Nm.
- Using a mounting iron, position the left and right roller mounts (4) without play on the overhead guard tube
sections and handtighten the mount fastening screws.
- Start the engine and tilt the mast forward and backward. This will adjust the rollers at the widest section
of the overhead guard practically without any play.
- Torque the roller mount fastening screws to 80 Nm.
To Next Page
Loading...
