Page 2
Section 4.5
Service Training
4.5.1 ACCELERATOR AND BRAKE PEDAL ADJUSTMENT
ACCELERATOR PEDALS
- Bring both accelerator pedals to the same level, position bracket (1) on the leg spring (2) and secure them
with screws.
- With the aid of the spacer (WM 6), adjust the hexagonal screws (3) and (7) to a clearance of 48 mm from
the pedal and lock them with locknuts.
- Position the travel control 55 mm (WM 6) from the side of the pedal and secure it with screws.
- Clamp the adjusting lever (4) on the travel control shaft (shaft is in the neutral position when delivered).
BRAKE PEDAL
- Slide the stop (8) for the non-depressed pedal full up in the elongated holes.
- Slide the adjusting lever (5) onto the brake shaft of the control. Using a flat 10 mm spanner, turn the shaft
clockwise as far as the stop and clamp the adjusting lever in this position.
- Slide the stop (8) in the elongated holes fully down and screw tight in this position. This will relieve the
stress on the stop in the travel control.
- Using the spacer (WM 6), adjust the hexagonal screw (6) so that it is 48 mm from the pedal and lock it
in this position with the locknut.
To Next Page
Loading...
