Linde H 80 D - Page 72

Service Training
Page 4.2
Section 14
09.04
HYDRAULIC CIRCUIT DIAGRAM, TYPE 353 -03
A WORKING HYDRAULICS
1 Control valve block consisting of:
2 Way valve (auxiliary hydraulics)
3 Way valve (auxiliary hydraulics)
4 Way valve (tilting)
5 Way valve (lifting)
6 Restrictor
7 Pressure reducing valve
8 2/2-way valve (pressure balance)
9 Maximum pressure valve, 265
+5
bar
10 Shuttle valve
11 Pressure holding valve
12 Tilt cylinder
13 Slow down valve
14 Lift cylinder H 50/H 60
15 Line breakage protection
16 Lift cylinder H 70/H 80
C STEERING CONTROL VALVE ASSEMBLY
17 Pressure relief valve
18 Make-up valve
19 Shock valve
20 Steering control valve
D STEERING CYLINDER
E BOOST PRESSURE PUMP
21 Restrictor
22 Gear pump, 23 cc/rev.
23 Way valve - auxiliary braking