D9U001GE4-0101_0528
Discharged accumulator
This status will be cancelled automatically when the bed switches to sleep mode.
The accumulator is regarded as discharged if the following condition is met:
► Dened decrease of voltage depending on discharging current
► This status is indicated by the accumulator status indicator ashing quickly.
► It is possible to use the electric CPR only to position the bed.
To cancel this status:
► Press button
.
10.2 Removing the Bed from Use
Remove the bed from use as follows:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Deactivate the accumulator.
► Remove accessories.
To prevent damage during storage:
► Pack or cover the bed and accessories.
► Ensure that storage conditions are the same as the operating conditions.
10.3 Deactivating the Accumulator
To avoid damaging the bed and the environment during storage:
► Deactivate the accumulator.
To deactivate the accumulator:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Activate the keypad by pressing the button
.
► Press the Thighrest Up + Thighrest Down + Trendelenburg Tilt buttons at the same time and hold them for 3 seconds.
The accumulator is deactivated.
To activate the accumulator again:
► Connect Power Cable to the mains.
Fig. Deactivation of the accumulator (Attendant Control Panel)
Fig. Deactivation of the accumulator (Nurse Control Panel)
To Next Page
Loading...
Need help?
General
