D9U001GE4-0101_0562
12.4 Hold Mode
Hold Mode can be used only when scales are stabilized.
It allows adding or removing bed accessories and other items without changing the weight value.
To activate Hold Mode:
► Wait until the scales are stabilized. The icon or will be
illuminated when the scales are stabilized.
► Press button until snowake icon appears on the display.
► Add or remove required accessories.
To deactivate Hold Mode:
► After adding or removing accessories wait
until the scales are stabilized (icon or is displayed).
► Press button .
► Display shows the original weight value.
To deactivate Hold Mode without xing the weight value:
► Press button .
12.5 Bed Overload
If the bed load is over 254.5kg:
► The “HIGH” is shown on the display.
NOTE If the bed is overloaded, it is impossible to position or manipulate the bed
until overloading is removed.
NOTE Bed overloading always has higher priority than Hold Mode and Taring.
12.6 Bed Underload
If the bed is underloaded:
► Display shows the „LOW“.
12.7 Weighing in tilt
Accuracy is conditioned by the spirit level, which is located on the right head corner of the bed.
If the bubble is in the highlighted circle then weighing is accurate.
12.8 Zeroing Scales
Zeroing is only possible in a range of ±5kg from factory zero.
Zeroing is used to reset weight on the display and set up user zero, which sets the maximum weight range of the weighing system.
Zeroing must be done with an empty, unloaded bed, without the mattress and accessories. Zeroing is done after installation, weight
verication or servicing.
To zero scales:
► Position the bed about 20 cm above the lowest position and set the mattress support platform to the horizontal position.
Ensure that nothing touches the bed except you.
► Press and hold button until weight value starts to ash.
► Press button to conrm zeroing.
“0” is shown on the display and an acoustic signal conrms zeroing.
To cancel zeroing:
► Press button
while zeroing.
Fig. HOLD Mode (iBoard
Basic)
Fig. Bed Overload (iBoard
Basic)
Fig. Bed Underload (iBoard
Basic)
To Next Page
Loading...
General
