D9U001GE4-0101_05
73
16.2 Infusion Stand
WARNING!
Risk of injury due to use of incorrect accessories or because of incorrect use!
Infusion Stands must only be used for their intended use. Always read the instructions for use!
► Only mount an infusion pump to the lower (wider) telescopic section of an infusion stand above the head/foot
board.
► Never mount an infusion pump to the upper (thiner) telescopic section of an infusion stand.
► Ensure the infusion pump will not collide with any movable parts of the bed (especially Backrest part) or with the
patient. This must be veried after installation.
► Do not over tighten the infusion pump clamps during tment. Over tightening may damage the infusion stand.
► Infusion pump can be only used if the infusion stand is tted in the accessory holder socket in the head end on
the under carriage of the bed.
► Do not use the infusion stand as driving/pushing device during the bed transport.
CAUTION!
Risk of collision with oxygen bottle holder on the bed end due to incompatibility!
► Use the foldable infusion stand with adapter to avoid the collision.
Infusion stands are intended to provide a suitable support for the attachment of the infusion pumps/syringe pumps and suspension
of the infusion bags or bottles.
Infusion stands can be tted to the head and foot end of the bed by either tting into the IV/Infusion sockets mounted on the bed or
using alternative accessory holder socket in the head end on the undercarriage of the bed.
► Use exclusively infusion stands with hooks for hanging IV bags or baskets for intravenous solutions.
► Ensure the infusion stand individual hook 2kg maximum Safe Working Load is not exceeded.
► Ensure the infusion stand maximum Safe Working Load is not exceeded.
► Follow the actual price list for information about types of infusion stands.
Fig. Infusion stand
Fig. Places for infusion stand (sleeve ttings on accessory adapter)
To Next Page
Loading...
Need help?
General
