Page G-2
MPS Motor Protection System Rev. 6-F-022117
Appendix G, MPS Revision History
APPENDIX A
RTD temperature menu updated.
APPENDIX B
RTD modules updated.
APPENDIX E
MPS registers 548 and 549 added.
REVISION 6-C-011515
SECTION 2
Figs. 2.8, 2.9, 2.10, and 2.11 updated.
SECTION 5
OPI menu updated in Section 5.24.
REVISION 6-B-061914
SECTION 1
Underpower and reversepower features added.
SECTION 5
Underpower (5.17) and reversepower (5.18) sections added.
SECTION 9
Terminal torque specification added.
Direct connection (Note 5) updated in Section 9.4.
APPENDIX A
Underpower and reversepower trip and alarm access added to messages and protection menus.
APPENDIX B
Underpower and reversepower protection set points added.
APPENDIX E
Underpower and reversepower added to communication database table.
APPENDIX F
Underpower and reversepower added to register formats table.
REVISION 6-A-101813
SECTION 1
Faceplate updated.
Series 2 features added.
HARDWARE REVISION HISTORY
HARDWARE UPDATE R
Updated opto-coupler relay drive circuit.
Updated non-volatile and RTC battery.
Update R can only be combined with hardware revisions older than 01J and 02C. It will be indicated with an
“Update R” label on the serial number label.
HARDWARE REVISION 02C
Updated opto-coupler relay drive circuit.
Updated non-volatile and RTC battery.
HARDWARE REVISION 02B
Power Supply: Power factor correction update.
Analog Module: ADC package changed.
HARDWARE REVISION 02A
Analog Module: Improved accuracy.
HARDWARE REVISION 02
Processor Module memory size increased.
Rev 02 required to enable waveform capture functionality.
HARDWARE REVISION 01J
Updated opto-coupler relay drive circuit.
Updated non-volatile and RTC battery.
HARDWARE REVISION 01H
Power supply updated.
To Next Page
Loading...