SCPC System • User menu and service menu
CP_SEM_60-03-00.002 33
4.2.1 Overview of keys and functions in the Service menu
Service menu pages 1 and 2 Function
Key symbol Next ➜ Move between the pages in the
Service menu
Key symbol Return (Return key) ➜ Exit Service menu, back to start page
Service menu page 1
Key symbol i-Probe Calib. Mode ➜ Calibration of the current sensor (e.g.
after replacing the batteries)
Key symbol Accept ➜ Confirm the successful calibration
and apply the value determined
Key symbol 00125h > 0h ➜ Reset the hours of operation counter
Service menu page 2 Function
Key symbol ZIS Flash Write ➜ Enable write access to the firmware
for serial interface (ZIS) circuit board.
The programming is carried out via an
external PC and the relevant Flash
software.
Key symbol ZIS Reset ➜ Manual reset of the serial interface
(ZIS) circuit board. This is also carried
out automatically when exiting the
Service menu.
To Next Page
Loading...
