LNS TRYTON 107 - 8. CYCLE AUTOMATIC

CHAPTER 8: OPERATION 85
TRYTON 107/112
7.5. Miscellaneous functions
Language
This parameter allows to adapt the language in which the messages
will appear, depending on the country of destination of the bar feed
system (for practical reason, it is not necessary to stop the bar
feeder to select a language).
Restore parameters
This function allows the restoring of saved parameters or the factory
settings of the barfeeder.
Once the barfeeder has run more than 20 production cycles, this
parameter is not shown anymore.
Automatic cycle (Dry-Run) emulation
This function allows the use the lathe (in the production cycle)
without the bar feed system (chuck work, pre-heating of the lathe,
etc.).
In order to activate this parameter, the pusher and the movable vise
must be in rear position and the main cover must be closed.
LANGUAGE: [@]
1:FRANÇAIS
2:ENGLISH
3:DEUTSCH
4:ITALIANO
5:ESPANOL
ESC ENTER
RESTORE PARAMETERS [@]
1:NO
2:SAVED PARAMETERS
3:FACTORY SETTINGS
ESC ENTER
DRY RUN MODE
PRESS ENTER TO START