Loadrite L2150 User Manual
3.6.2.1. Auto-Add
The Auto-Add functionality is only available if enabled at installation. Some features may not be available,
depending on your model of Loadrite Weighing System.
The Loadrite Weighing System can be set to automatically add a bucket load when lifted past the Trigger Point for a specified
number of seconds OR when the bucket is rotated forward to tip off the load. This means that you don't need to
press after lifting each load.
Depending on installation setup:
Bucket loads may not be added if under a specified amount
Auto-Add may be turned on or off via the Setup Menu or by pressing (Auto-Add toggle).
3.6.2.1.1. Turn Auto-Add On or Off
1) Press twice.
The Main Menu will display.
2) Press or to scroll up or down until Auto-Add is selected, then press .
3) Complete the following:
use the arrow buttons to select On, then press .
use the arrow buttons to select Off, then press .
4) Press to return to the Total screen.
3.6.2.1.2. Auto-Add toggle
The Auto-Add toggle functionality may or may not be available depending the configuration of your Indicator.
You can toggle between using Auto-add and using the normal add process from the Total screen.
Turn Auto-Add on
1) From the Total screen, press .
The Auto-Add On? message will display.
2) Press .
The message will change to Auto-Add On and the Total screen will display.
Turn Auto-Add off
1) From the Total screen, press .
The Auto-Add Off? message will display.
2) Press .
The message will change to Auto-Add Off and the Total screen will display.
To Next Page
