Loadrite L2150 - How Do I Finish the Load; How Do I Put the Indicator into Standby Mode

3-17
Loadrite L2150 User Manual
3.7. HOW DO I FINISH THE LOAD?
When you have finished adding bucketloads to the truck, you must clear the short total.
To clear the short total, complete the following:
 Press and hold .
The short total will display briefly, followed by the Total Cleared message, then the Total screen.
For more information on the short total, see "The short and long totals" on page 4-19.
3.8. HOW DO I PUT THE INDICATOR INTO STANDBY MODE?
If you are not going to use the Loadrite Weighing System for a while, you can put the Indicator into Standby mode by completing
the following:
Option 1
 Press and hold for 5 seconds.
The Indicator will enter Standby mode.
Option 2
1) Press .
2) Press or to scroll up or down until Standby is selected, then press .
The Indicator will enter Standby mode.
Option 3
The Loadrite Indicator will automatically go into Standby mode if it is not used for two hours.
How do I exit Standby mode?
 Press any button to exit Standby mode.
Either the Login screen or Total screen will display.