Logan X90 - Page 217

19B-8
EXHAUST
Catalytic converter
K7M, and 710
19B
Remove:
-the catalytic converter mountings from the exhaust
manifold,
-the catalytic converter.
IF REPLACING THE CATALYTIC CONVERTER
Remove the oxygen sensor from the catalytic con-
verter.
REFITTING
Refit the oxygen sensor.
Tighten to torque the oxygen sensor (4.5 daNm)
using tool (Mot. 1495).
Fit:
- the catalytic converter,
- the sleeve (see 19A, Exhaust, General informa-
tion).
Torque tighten the catalytic converter mounting
nuts (2.1 daNm).
Tighten the sleeve while supporting the exhaust pipe
to ensure they are aligned.
Proceed in the reverse order to removal.
107926
109399
WARNING
Be sure to replace the sealing ring between the
exhaust manifold and the catalytic converter.