19C-8
RESERVOIR
Pump / sender unit / filter
K7J or K7M, and 710
19C
Remove the flap providing access to the pump/gau-
ge/filter assembly.
Disconnect:
-the fuel pump connector,
-the pipe to the pump/gauge/filter assembly.
Remove the locking ring from the pump/gauge/filter
assembly using tool (Mot. 1397).
Allow the fuel in the pump/gauge/filter assembly to
run out.
Remove the pump/gauge/filter assembly, being ca-
reful not to damage the float.
109177 109176
WARNING
If several hours are to pass between the pump/
gauge/filter assembly being removed and refitted,
tighten the locking ring on the fuel tank to prevent
any damage.
To Next Page
Loading...