EasyManua.ls Logo

Lonking CDM853 - 4.6.2 OPERATIONSTOBECARRIEDOUTAFTERCOMPLETIO; 4.6.3 AFTERCOLDWEATHERHASENDED

Lonking CDM853
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
102
Be sure not to use any anti-freezing fluid which contains methanol, ethanol or
propanol.
Be sure not to use any anti-leakage agent, no matter
it
is used alone or together with
anti-freezing fluid.
Be sure not to mix up anti-freezing fluids of different designation.
When replacing the anti-freezing fluid, please refer to the nameplate on the rear end
of the loader for the concentration of anti-freezing fluid.
NOTE:
NOTE:
NOTE:
NOTE: The
The
The
The anti-freezing
anti-freezing
anti-freezing
anti-freezing fluid
fluid
fluid
fluid shall
shall
shall
shall be
be
be
be kept
kept
kept
kept away
away
away
away from
from
from
from open
open
open
open flame,
flame,
flame,
flame, and
and
and
and no
no
no
no smoking
smoking
smoking
smoking
is
is
is
is permitted
permitted
permitted
permitted when
when
when
when filling
filling
filling
filling the
the
the
the anti-freezing
anti-freezing
anti-freezing
anti-freezing fluid.
fluid.
fluid.
fluid.
3. Precautions for Use of Battery
1. When the ambient temperature lowers, the capacity of the battery will reduce. If the
charging rate of the battery is too low, the electrolyte may get frozen. Therefore, if
possible, remain the charging rate
at
100%, and preserve the temperature as possibl e ,
so as to ensure that the engine can be started up easily in the next day.
2. In areas where the atmospheric temperature is extremely low, please use the battery
which can withstand the cold.
4.6.2
4.6.2
4.6.2
4.6.2 OPERATIONS
OPERATIONS
OPERATIONS
OPERATIONS TO
TO
TO
TO BE
BE
BE
BE CARRIED
CARRIED
CARRIED
CARRIED OUT
OUT
OUT
OUT AFTER
AFTER
AFTER
AFTER COMPLETION
COMPLETION
COMPLETION
COMPLETION OF
OF
OF
OF
WORKS
WORKS
WORKS
WORKS IN
IN
IN
IN EACH
EACH
EACH
EACH DAY
DAY
DAY
DAY
In order to prevent the mud, water or snow on the loader from getting frozen and ensure
that the loader can be used in the next day, be sure to complete the following operations:
1. Thoroughly clear away the mud, water or snow on the loader, and prevent the
sealing performance from being damaged because mud, water or snow enters into sealed
portion and then gets frozen.
2. Park the loader on a dry and hard ground. If no such a ground is available, park the
loader on a wood plank. The use of wood plank may prevent the loader from being frozen
to the ground and ensure the normal use in the next day.
3.
At
low temperature, the capacity of the battery will reduce obviously as the storage
time lasts. Be sure to cover the battery, or move
it
to a warm place and install
it
onto the
loader for working in the next day.
4.6.3
4.6.3
4.6.3
4.6.3 AFTER
AFTER
AFTER
AFTER COLD
COLD
COLD
COLD WEATHER
WEATHER
WEATHER
WEATHER HAS
HAS
HAS
HAS ENDED
ENDED
ENDED
ENDED
After the weather becomes warm as the season changes, please carry out the following
works:
1. The semi-sticky fuel, hydraulic oil and lubricating oil shall be used for all parts.

Table of Contents