1. Drive the machine to park
at
a flat ground; slowly move the car with low oil supplying,
to keep the oil outlet screw piston
at
the end side of the wheel rim of the front drive axle to
be located
at
the lowest position.
2. As the oil outlet screw pistons
at
the end side of the wheel rim of the front drive axle
cannot be located
at
the lowest position
at
the same time, therefore, the front and rear
drive axles should replace oil twice.
3. Rotate the button of the parking brake to reset it. The handle of the speed changing
should be placed
at
neutral position, put on frame fixing bar to avoid car moving and
rotating.
4. Run the engine for 10 minutes under idle speed, and the engine turns off.
5. Screw off the oil outlet screw piston
at
the end surface of the wheel rim of the front
drive axle, and the oil outlet screw piston
at
the middle part of the axle, drain out the oil
and receive the oil with container.
6. Refuel according to the above-mentioned “ drive axle refueling and oil level judgment
criteria ” .
7. Screw on the oil outlet screw piston.
8. Repeat the procedure to inspect the oil level of the rear drive axle
9. Since the oil may
at
relatively high temperature,
it
is necessary to wear protection
tools and facilities, and handle with care to avoid injuries.
5.12
5.12
5.12
5.12 INSPECTION
INSPECTION
INSPECTION
INSPECTION AND
AND
AND
AND REPLACEMENT
REPLACEMENT
REPLACEMENT
REPLACEMENT OF
OF
OF
OF TIRE
TIRE
TIRE
TIRE
If
If
If
If the
the
the
the tire
tire
tire
tire or
or
or
or wheel
wheel
wheel
wheel rim
rim
rim
rim is
is
is
is handled
handled
handled
handled mistakenly,
mistakenly,
mistakenly,
mistakenly, tire
tire
tire
tire may
may
may
may burst
burst
burst
burst or
or
or
or broken
broken
broken
broken and
and
and
and wheel
wheel
wheel
wheel
rim
rim
rim
rim may
may
may
may be
be
be
be damaged
damaged
damaged
damaged and
and
and
and spread,
spread,
spread,
spread, which
which
which
which may
may
may
may result
result
result
result in
in
in
in serious
serious
serious
serious injury
injury
injury
injury or
or
or
or death.
death.
death.
death.
Maintenance, dismount, repair and installation of tire and wheel rim need special
equipment and know- how, so you must bring
it
to tire repair shop to repair, or
by
specially
trained personnel to carry out and comply with all relevant safety requirements.
Recommend to use dry nitrogen (N2) to full the tires. If the original tires are filled with
air,
it
is recommended to use nitrogen gas to adjust its air pressure, nitrogen can be mixed with
atmospheric gases. Tires filled with nitrogen can reduce the poss ibility of explosion.
When tire pressure is inspected and adjusted,
it
should be carried out after the tire is fully
cooled.
Pressure of Nitrogen inflated tire is the same as that of the air-inflated tire.
5.13
5.13
5.13
5.13 MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE FOR
FOR
FOR
FOR LONG
LONG
LONG
LONG TIME
TIME
TIME
TIME PARKING
PARKING
PARKING
PARKING
If the machine will be stored for a long time exceeding one month, the following steps
Warning
Warning
Warning
Warning
To Next Page
Loading...