Lonking CDM853 - 1.6.11 PRECAUTIONSFORBATTERYCHARGE; 1.7 MAINTENANCEPRECAUTIONS; 1.7.1 FAULTNOTIFICATION; 1.7.2 CLEANINGBEFOREREPAIRANDMAINTENANCE

44
or touch the machine.
1.6.11
1.6.11
1.6.11
1.6.11 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS FOR
FOR
FOR
FOR BATTERY
BATTERY
BATTERY
BATTERY CHARGE
CHARGE
CHARGE
CHARGE
1.7
1.7
1.7
1.7 MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
1.7.1
1.7.1
1.7.1
1.7.1 FAULT
FAULT
FAULT
FAULT NOTIFICATION
NOTIFICATION
NOTIFICATION
NOTIFICATION
If processing maintenance has not mentioned in Operation Manual, it can lead to
unexpected fault. Then please contact to designated dealer of LONKING Holdings Limited
for repair.
1.7.2
1.7.2
1.7.2
1.7.2 CLEANING
CLEANING
CLEANING
CLEANING BEFORE
BEFORE
BEFORE
BEFORE REPAIR
REPAIR
REPAIR
REPAIR AND
AND
AND
AND MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
If use the wrong method to charge the battery, it
may cause battery explosion. Therefore, it is
important to abide by the related charge
regulations and instructions stipulated in the
manual and note the following tips.
Choose a well-ventilated place to charge the
battery. Remove the battery cap to release
hydrogen gas and prevent explosion.
Set the charger voltage value to be consistent
with battery voltage value. If the voltage is
wrongly set, it may cause charger overheating or
fire and explosion.
Connect the charger ’ s positive (+) clip to positive
(+) terminal of battery, correspondingly, connect
negative (-) clip to negative (-).
IF the charge rate of the battery is less than 1/10,
give high-speed charging and set the values into
the rated capacity of the battery. If the charge
current is too large, it may cause electrolyte
leakage or evaporation, which may catch fire or
cause exp losion.