5.10.2
5.10.2
5.10.2
5.10.2 TRANSMISSION
TRANSMISSION
TRANSMISSION
TRANSMISSION OIL
OIL
OIL
OIL REPLACEMENT
REPLACEMENT
REPLACEMENT
REPLACEMENT
It
is required to replace transmission oil within the regulated oil change cycle. And the
replacement procedures are as follows:
1. Park the machine on the flat ground, and set the speed shifting handle in neutral gear
shift, rotate the button of the parking brake to reset, and put on a fixed frame rod, to
prevent the car from moving and rotating.
2. Start the engine and run
it
at
idle speed, when the engine oil temperature reaches its
operating temperature (about 80 ℃ ~ 90 ℃ ), the engine turns off.
3. Drain out the oil
by
unscrewing the oil outlet screw piston
at
the bottom of the gear box .
As the oil is still
at
a higher temperature, therefore
it
requires wearing protective
equipment, and careful operation, so as to avoid personal injury.
4. When replacing transmission oil,
it
is necessary to replace the fine filter of the gearbox
as well.
5. Remove the transmission oil pan. Clean the filter screen with compressed air or diesel
fuel.
6. Install transmission oil pan, drain plug and corresponding sealing elements.
Refueling port of the gearbox is at the left side of
the frame articulated section; please inspect the
oil level of the gearbox regularly according to the
Gearbox may be damaged if its oil level is too
high or too low. Please keep transmission oil
level in the correct position.
Fill from the refueling port of the gearbox.
When the engine stopped, oil is drained out from
the screw piston at the upper oil level;
When the engine runs, the minimum oil level
does not lower than the screw piston at the
In course of inspecting oil level of gearbox,
replacing transmission oil and replacing the fine
filter of the gearbox. We must pay great attention
to the cleanliness, prevent the dirt from entering
the transmission system and avoid damage to
To Next Page
Loading...