2. After the loader has driven onto the towing tractor or truck, no turning operation may
be carried out in the course of transportation. If
it
is necessary to carry out turning
operation, please carry out the operation only after the loader has returned to flat
ground.
3. After the loader is parked properly, use the bumper to fix the front/rear frames.
4. Horizontally place the bucket on the transportation vehicle, and then set the control
handle
at
the neutral position.
5. Pull the pilot joystick to the middle position.
6. Rotate the parking brake button to reset it.
7. Turn off the engine, set all switch
at
middle position or off position, and then pull out
the electric lock key.
8. Properly close and lock all doors, and then pull out the key.
9. Pull the negative pole switch of battery to the OFF position.
10. When using a truck or towing tractor to transport the loader, be sure to use chocks to
block up the wheels and use wire ropes to fix the loader, so as to prevent the loader from
moving in the course of transportation.
4.5.1
4.5.1
4.5.1
4.5.1 HOISTING
HOISTING
HOISTING
HOISTING OF
OF
OF
OF LOADER
LOADER
LOADER
LOADER
1. The hoisting operation shall be commanded and carried out
by
professionals who
Figure: Use Chock to Block up the Wheels of the
Towing Tractor
Figure: Installation of frame fixing rod
To Next Page
Loading...