Lonking CDM853 - 5.10 TRANSMISSIONOILMAINTENANCE; 5.10.1 INSPECTOILLEVELOFGEARBOX

135
5.10
5.10
5.10
5.10 TRANSMISSION
TRANSMISSION
TRANSMISSION
TRANSMISSION OIL
OIL
OIL
OIL MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
5.10.1
5.10.1
5.10.1
5.10.1 INSPECT
INSPECT
INSPECT
INSPECT OIL
OIL
OIL
OIL LEVEL
LEVEL
LEVEL
LEVEL OF
OF
OF
OF GEARBOX
GEARBOX
GEARBOX
GEARBOX
When perform soldering on the whole machine,
follow the following regulations to avoid damage
to machinery and security incidents.
1.
Before soldering, shut down the engine,
unplug the key switch, turn off the negative
pole switch of battery;
2.
Before soldering, must remove the wiring
harness connectors of the dashboard to
avoid damage to instrument;
3. While welding, must keep away from the wire
bund of the machine and take measures to
avoid flash and the damage caused by flying
sparks;
4. Continuously use the voltage more than 200V ;
5. Keep the length of the cable between
soldering region and grounding is of within
1m;
6. Avoid to arrange the seals and bearings in
the area between the soldering region and
the grounding cable;
7. Do not weld the pipe with fuel, engine oil and
hydraulic oil;
8. Do not weld containers sealed or with poor
ventilation.