Lonking CDM853 - 1.8.12 NOLEAVINGOFFOREIGNMATTERINSIDEMACHINE; 1.8.13 PRECAUTIONSINTHEUSEOFHAMMER; 1.8.14 WELDINGREPAIR

51
1.8.12
1.8.12
1.8.12
1.8.12 NO
NO
NO
NO LEAVING
LEAVING
LEAVING
LEAVING OF
OF
OF
OF FOREIGN
FOREIGN
FOREIGN
FOREIGN MATTER
MATTER
MATTER
MATTER INSIDE
INSIDE
INSIDE
INSIDE MACHINE
MACHINE
MACHINE
MACHINE
When opening the repair windows or refueling port of fuel for repair, pay caution not to let
any foreign objects drop (such as nuts, bolts, cotton, or tools) into the hood. If there is
thing falling within the machine, it will cause damage to the machine, operational failures
and other
faults.
If there is any foreign object falling into the machine, make sure to remove it from the
inside of the machine.
During maintenance, do not carry any unnecessary tools and spare parts in the pockets.
1.8.13
1.8.13
1.8.13
1.8.13 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS IN
IN
IN
IN THE
THE
THE
THE USE
USE
USE
USE OF
OF
OF
OF HAMMER
HAMMER
HAMMER
HAMMER
When using a hammer, be sure to wear safety glasses, safety helmets and other
protective clothing, and place a brass rod between the hammer and area being
hammered.
1.8.14
1.8.14
1.8.14
1.8.14 WELDING
WELDING
WELDING
WELDING REPAIR
REPAIR
REPAIR
REPAIR
Welding operation should be performed by qualified welders, and conduct in place fitted
with appropriate equipment. Welding will produce gas, so there is hazard of causing fire
and electric shock when doing welding. Therefore welding must comply with the following
notes:
• Disconnect the connection of the battery terminals to
prevent
battery explosions.
• Clear the paint of welding parts to prevent harmful
gases.
• When welding on the hydraulic device or pipe, or near
them, it will produce combustible vapors and sparks
Do not touch any joystick. If it is indispensable to
operate joystick, you must notify other workers to
walk away to safe place.
When hammering hard parts, such as a pin or a
bearing, there will be the injury risk of debris
flying into the eye.