EasyManua.ls Logo

Lonking CDM853 - 4.5 TRANSPORTATIONOFLOADER

Lonking CDM853
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
97
The shuttling work method is mainly used for the combined work of loader and truck
fleet. As indicated in the figure below, after the loader is loaded with materials,
it
will
travel backwards
by
2-3 times the width of the truck. Thereafter, the truck will run
along one side of the loader and stop in front of the loader. The loader will go ahead
and raise up the lift arm. After the materials are discharged, the loader will travel
backwards to the original position. If the truck is not fully loaded, the tru ck will go
ahead
by
the width of the truck. After completing the next shovel-loading operation,
the loader will return to the original position, and then the truck which is not fully
loaded will travel backwards until
it
is in front of the loader, and now the loader will
discharge the materials onto the truck. Repeat this operation until the truck is fully
loaded, and then load the next truck. This working method requires the close
cooperation between the loader driver and the truck driver, and, if necess
ary,
the use
of horn, light or gesture for communication.
4.5
4.5
4.5
4.5 TRANSPORTATION
TRANSPORTATION
TRANSPORTATION
TRANSPORTATION OF
OF
OF
OF LOADER
LOADER
LOADER
LOADER
Before the transportation, be sure to survey the height, width and permissible load of the
transportation course. The total height, total width and total weight after the loader is
placed on the transportation vehicle may not exceed the specified value. I f the height or
width exceeds the specified value, please consult with LONKING Holdings Limited or its
distributor for solution.
In order to prevent the safety accident caused
by
unexpected movement or sliding of the
loader in the course of transportation, be sure to clear away ice, snow and other slippery
materials on the dock or vehicle before the transportation.
NOTE:
NOTE:
NOTE:
NOTE: When
When
When
When transporting
transporting
transporting
transporting the
the
the
the loader,
loader,
loader,
loader, please
please
please
please comply
comply
comply
comply with
with
with
with the
the
the
the national
national
national
national or
or
or
or local
local
local
local
regulations
regulations
regulations
regulations relating
relating
relating
relating to
to
to
to height,
height,
height,
height, width,
width,
width,
width, length
length
length
length and
and
and
and weight.
weight.
weight.
weight.
Please carry out the transportation in accordance with the following procedure:
Before the transportation, be sure to block up the wheels of the towing tractor or truck
with chock (towing tractor in the figure).
Figure: Shuttling Work Method

Table of Contents