③ Apply the anti-corrosion lubricating oil onto the unpainted or exposed surfaces.
Use insulating compound to protect wires and terminates. On the damaged
surfaces, use paint or appropriate antirust agent to prevent rust or corrosion.
4.7.3
4.7.3
4.7.3
4.7.3 PERATION
PERATION
PERATION
PERATION IN
IN
IN
IN DUSTY
DUSTY
DUSTY
DUSTY OR
OR
OR
OR SANDY
SANDY
SANDY
SANDY AREA
AREA
AREA
AREA
1. In most areas, the loader may generate dust in the course of work. However, when the
loader is used in a place where there is a lot of dust and sand, protective measures
shall be taken.
2. Keep the cooling system and cooling areas clean, clean them up with compressed
air,
and take this measure as frequently as possible.
WARNING:
WARNING:
WARNING:
WARNING: When
When
When
When using
using
using
using the
the
the
the compressed
compressed
compressed
compressed air,
air,
air,
air, please
please
please
please wear
wear
wear
wear the
the
the
the safety
safety
safety
safety goggles
goggles
goggles
goggles
1. When maintaining or repairing the fuel system, be careful so as to prevent dust and
sand from getting into the fuel pipeline.
2. Maintain the air filter from time to time, inspect the air control indicator every day, and
keep the dust cover and dust valve clean.
Try
best to prevent dust and sand from
entering into any part of engine.
3. Lubricate the loader in accordance with the lubrication sign and lubrication interval
table on the loader. Before carry out the lubrication, clean up all lubrication nipples,
because the sand in the lubricating oil may cause the wear and accelerated wear of
parts.
4. Keep the loader as clean as possible. Park the loader under canopy or cover
it
with
tarpaulin, so as to protect the loader against the corrosion caused
by
wind and sand.
4.7.4
4.7.4
4.7.4
4.7.4 PERATION
PERATION
PERATION
PERATION IN
IN
IN
IN RAINY
RAINY
RAINY
RAINY AND
AND
AND
AND HUMID
HUMID
HUMID
HUMID ENVIRONMENT
ENVIRONMENT
ENVIRONMENT
ENVIRONMENT
The precautions for operation in rainy environment are similar with those for operation
under high temperature conditions.
Apply lubricating oil onto all exposed surfaces, especially damaged and unpainted
surfaces. Apply lubricating oil onto the location where the paint is damaged as soon as
possible, so as to prevent corrosion.
4.7.5
4.7.5
4.7.5
4.7.5 PERATION
PERATION
PERATION
PERATION IN
IN
IN
IN SALT
SALT
SALT
SALT WATER
WATER
WATER
WATER
Salt water and sea water is highly corrosive. When operating the loader in salt water,
please pay special attention to the following matters:
1. After the loader is stained with salt water, immediately wash
it
with fresh water and
then dry
it
up.
2. Apply anti-corrosion lubricating oil onto all surfaces which contact with salt water,
especially those surfaces where the paint is damaged.
To Next Page
Loading...