1.6.1
1.6.1
1.6.1
1.6.1 METHODS
METHODS
METHODS
METHODS OF
OF
OF
OF USING
USING
USING
USING A
A
A
A BRAKE
BRAKE
BRAKE
BRAKE
Do not put your feet on the brake pedal unless
it
is necessary.
Do not frequently step the brake pedal unless
it
is necessary.
When walking down hill, take the engine as a brake, never use gear shifting or place the
gearbox in neutral position.
1.6.2
1.6.2
1.6.2
1.6.2 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS WHEN
WHEN
WHEN
WHEN OPERATING
OPERATING
OPERATING
OPERATING ON
ON
ON
ON SNOWY
SNOWY
SNOWY
SNOWY DAYS
DAYS
DAYS
DAYS
When the machine working on the snowy or icy road, even a small slope can make the
machine slide aside, therefore
it
is important to low the walking speed and avoid a sudden
start, stop or sharp turn, because
it
has danger of sliding, especially when the machine is
in uphill or downhill status.
On the freezing road, when the temperature rises, the ground will become soft, so the
walking condition will become unstable, in this case, be careful to operate the machine.
After heavy snow, the objects on the road shoulders and roadside were buried in the
snow and unclear to see, so be careful to wipe the snow.
When walking on the snow-covered slope,
it
is not completely exert a sudden brake.
To
slower the speed,
it
is correct to use engine as a brake, meanwhile, step the brake pedal
for several times. If necessary, lower the bucket down to the ground to stop th e machine.
The adhesion force of the ground may greatly change with the effects of the snow.
Therefore,
it
is necessary to adjust loading capacity to avoid machine sliding aside when
walking.
1.6.3
1.6.3
1.6.3
1.6.3 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS FOR
FOR
FOR
FOR OPERATION
OPERATION
OPERATION
OPERATION IN
IN
IN
IN COLD
COLD
COLD
COLD AREAS
AREAS
AREAS
AREAS
After the completion of operation, clean off the water, snow or mud that clung to wires,
cable connectors, switches or sensors, as well as covering parts.
Totally
preheat the machine. Prior to the operation of joystick, the machine will response
slowly if
it
is not totally preheated, this may lead to unexpected accidents.
Operate all joysticks to circulate hydraulic oil in hydraulic system (increase the system
pressure to a specified value, then release the pressure, drain the oil to hydraulic oil tank)
The machine shall be equipped with anti-skid tire
chains when walking on the snow-covered road.
To Next Page
Loading...