Lonking CDM853 - 1.7.3 KEEPCLEANNESSOFWORKPLACE; 1.7.4 DESIGNATIONOFRESPONSIBLEPERSON; 1.7.5 CHECKINGWATERLEVELOFRADIATOR

45
1.7.3
1.7.3
1.7.3
1.7.3 KEEP
KEEP
KEEP
KEEP CLEANNESS
CLEANNESS
CLEANNESS
CLEANNESS OF
OF
OF
OF WORKPLACE
WORKPLACE
WORKPLACE
WORKPLACE
Do not leave any maintenance tool around in the workplace. Please wipe out all the
grease, lubricants, or other things that may make people slip completely.
Do keep the workplace clean and tidy in order to work safelyand avoid danger of tripping,
slipping, falling and alike, resulting in injuries.
1.7.4
1.7.4
1.7.4
1.7.4 DESIGNATION
DESIGNATION
DESIGNATION
DESIGNATION OF
OF
OF
OF RESPONSIBLE
RESPONSIBLE
RESPONSIBLE
RESPONSIBLE PERSON
PERSON
PERSON
PERSON
During repair of machinery, loading and unloading equipments, or cooperation with others ,
one principal should appoint whose order the others should obey, which will avoid
misunderstanding that resulting in serious accidents.
1.7.5
1.7.5
1.7.5
1.7.5 CHECKING
CHECKING
CHECKING
CHECKING WATER
WATER
WATER
WATER LEVEL
LEVEL
LEVEL
LEVEL OF
OF
OF
OF RADIATOR
RADIATOR
RADIATOR
RADIATOR
When checking water level in radiator, be sure to stop engine, wait until the cool down of
engine and radiator before checking water level check in the water tank.
If you need to open the radiator cap, comply with the following methods:
• Check water temperature before the compressor down.
• When the filler cap is cool enough to be open by bare hand, loose the radiator filler
cap to release its inner pressure and then open the top cap.
It needs to clean up the machine before repair
and maintenance. This ensures that no waste
enters into the machine, as well as the smooth
and safe process of maintenance
When performing cleaning, pay attention to the
following items:
1. Wear non-slip shoes to prevent falling down
from the wet or oil surface.
2. When using high-pressure water to wash
machine, please wear protective clothing to
avoid the impact of the high-pressure water,
such as hurting the skin or wastes, mud
splashed into the eyes.
3. Prohibit water spray onto components of the
electrical system (like sensor, wiring plug
connector), in case that water goes into
electrical system that causes malfunctioning.