Lonking CDM853 - 5.11 MAINTENANCEOFDRIVEAXLEOIL; 5.11.1 INSPECTOILLEVELOFDRIVEAXLE; 5.11.2 REPLACEMENTOFTHEDRIVEAXLEOIL

137
7. Refuel the clean transmission oil from the oil filling pipe of the gearbox, and inspect
the oil level of gearbox according to the above method, and fill to the regulated oil
level.
8. Before replacing transmission oil, cover the parking brake well to prevent the friction
plate of parking brake from oil and reduce the brake performance.
5.11
5.11
5.11
5.11 MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE OF
OF
OF
OF DRIVE
DRIVE
DRIVE
DRIVE AXLE
AXLE
AXLE
AXLE OIL
OIL
OIL
OIL
5.11.1
5.11.1
5.11.1
5.11.1 INSPECT
INSPECT
INSPECT
INSPECT OIL
OIL
OIL
OIL LEVEL
LEVEL
LEVEL
LEVEL OF
OF
OF
OF DRIVE
DRIVE
DRIVE
DRIVE AXLE
AXLE
AXLE
AXLE
Inspect the oil level of the drive axle according to the regulated cycle.
Too high or too low oil level of drive axle will result in damages to drive axle, and keep the
oil level of the drive axle in the correct position.
Drive axle fueling and oil level judging criteria:
Fill oil from the filling port of the left and right wheels, and take the oil overflowing out with
the middle oil piston of the axle off as the oil fully filled.
Inspection procedures:
1. Drive the machine to a flat and open ground, slowly move the machine with low oil
charging, keep the oil level mark of the front drive axle wheel-side to be located at the
level position.
2. As the oil level meter lines of front and rear drive axle cannot simultaneously locate in
a horizontal position, so the oil level of front and rear drive axle should be inspected
twice.
3. Rotate the parking brake handle for braking. Place the speed changing handle in
neutral gear position, and put on a fixed pole frame to prevent the car moving and
rotating.
4. Let the engine run 10 at idle speed.
5. Remove the oil outlet screw piston, the oil level inside the drive axle should be located
at the lower edge of the oil outlet port. If the oil level is below the lower edge of the oil
outlet port, it requests to add clean drive axle oil. Observe 10 minute s after fueling to
confirm the oil level is stable or not.
6. Screw on the oil outlet piston.
7. Inspect the oil level of the rear driving according to the above operation procedures.
5.11.2
5.11.2
5.11.2
5.11.2 REPLACEMENT
REPLACEMENT
REPLACEMENT
REPLACEMENT OF
OF
OF
OF THE
THE
THE
THE DRIVE
DRIVE
DRIVE
DRIVE AXLE
AXLE
AXLE
AXLE OIL
OIL
OIL
OIL
It requires replacing drive axle oil within regulated cycle.
The replacement procedures are as follows: